12:05 Garage- ’70 Duster build

You’re running an 18” up front correct? And the caliper hits. I have 17” Foose Knuckle, when your bracket is done would you be selling any additional ones? I already have a set of hubs machined. Just looking for a bracket, hopefully to run the mustang GT 13.2”


I am running 18s, but the diameter isn't the problem. THe front face of the caliper extends about 2" past the wheel mounting surface. It contacts the spoke on my wheel. Its' close and could probably be fixed with a 1/4"-3/8" spacer, but I don't want spacers. I'm not going to make a braket for these since I can't use them. By the looks of the GT500 calipers, the front section appears to be much shorter than this viper caliper.