I was able to get my car back on the ground and fired it up and moved it out of the garage so I can sweep the floor and clean up my mess. After getting my trans rebuilt and replacing, clutch,pressure plate and throwout bearing along with a rear main seal, HV oil pump, pan gasket, 90 degree oil filter adaptor gaskets and having my flywheel cut, oh and clutch linkage was also rebuilt. I went for a few mile ride and its like driving a different car. Trans used to be noisy through 1st and 3rd gear. I guess the bad output shaft bearing and almost non existent pilot bushing were causing the noise. Now its so quiet and all I hear is the exhaust note. Drove great for the few miles I did get to drive it. Back under the cover on the ground and bone dry on the floor. My huge project is a success.