Turn signal switch wiring

The early models, had a larger rectangle connector there. Later models have a long flat connector that will thread though openings in those column collars.
Unless you are willing to take the early column collars off you would have to depin the terminals in that early connector and pull wires only out and back in again. Depinning those terminals isn't easy even with the correct tools. Todays aftermarket will include the male/switch side connector, (separate from the wire terminals) but there was a time when a replacement switch did not include a new male/switch side connector. If you destroyed that connector, one option was cut the female/harness side connector off and make the wires up individually.
Where to buy the matching female/harness side connector today? This might be it.... MN3254 - 1963-69 Mopar; Turn Signal Switch Connector
but doesn't include the female terminals. So what do we do... buy both male and female molex connectors with terminals. something like this... https://www.amazon.com/dp/B07DLQGMD5/?tag=fabo03-20