Throttle for 64 Dart Help
EDIT: here is a close up picturei just ran out and took. The Lokar AT kickdown cable comes with a little bracket I attached that in an upwards position secured by the kickdown nuts. This allowed me to run the throttle cable through the top of the smaller bracket more in line with the carb. After a couple different positions I found this caused the least resistance. Also, you definitely need to trim the cable housing or there will be too much bind on the pedal - make sure to pull the ferule BACKWARDS on the housing before cutting with a cut off wheel... If you take it off good luck getting it back on! A shot of dry lube down the housing is a good idea.
Link here>>>>>>>>>>>
EDIT: here is a close up picturei just ran out and took. The Lokar AT kickdown cable comes with a little bracket I attached that in an upwards position secured by the kickdown nuts. This allowed me to run the throttle cable through the top of the smaller bracket more in line with the carb. After a couple different positions I found this caused the least resistance. Also, you definitely need to trim the cable housing or there will be too much bind on the pedal - make sure to pull the ferule BACKWARDS on the housing before cutting with a cut off wheel... If you take it off good luck getting it back on! A shot of dry lube down the housing is a good idea.
