Recommendations for a stainless steel flaring tool
I did stumble on to an easy trick for adding the return line. I found fuel return line clips which were 3/8s and 1/4s, bent down the 1/4s end and combined two clips together. This produced a solid clip with a nice gap to attach my feed and return lines together. This is helpful in the two pinch areas, going through the frame and especially going over the four link frame support. Using the clips, not only secures the lines but provides a nice gap so the lines do not rub.
I hope to be finishing running the lines and attaching to the regulator this weekend. Getting closer to being back on the road
I did stumble on to an easy trick for adding the return line. I found fuel return line clips which were 3/8s and 1/4s, bent down the 1/4s end and combined two clips together. This produced a solid clip with a nice gap to attach my feed and return lines together. This is helpful in the two pinch areas, going through the frame and especially going over the four link frame support. Using the clips, not only secures the lines but provides a nice gap so the lines do not rub.
I hope to be finishing running the lines and attaching to the regulator this weekend. Getting closer to being back on the road