In need of a engine measurment
yeah, the kit I bought was a bad deal. I am trying t salvage as much as I can to cut my losses. The HDK parts will allow me to move forward with a full mustang II front end, but again its another rough $2k which I dont have. I have bought the upper parts of it to replace the parts I have due to interference reasons. And the HDK upper coil over mounts are a much better designed.
I had another set of lower control arms (shown below) built based on the original set for $1500.
I really like how they turned out and I hope to be able to keep them. After mock up, I found they need each joint arm lengthen another 1.5 inches.
All in all, I am hoping once done it will turn out great.
My build thread. As of now, 11 pages of hardly no movement and lots of research.
Jeep 4.0 in 69 Barracuda
yeah, the kit I bought was a bad deal. I am trying t salvage as much as I can to cut my losses. The HDK parts will allow me to move forward with a full mustang II front end, but again its another rough $2k which I dont have. I have bought the upper parts of it to replace the parts I have due to interference reasons. And the HDK upper coil over mounts are a much better designed.
I had another set of lower control arms (shown below) built based on the original set for $1500.
I really like how they turned out and I hope to be able to keep them. After mock up, I found they need each joint arm lengthen another 1.5 inches.
All in all, I am hoping once done it will turn out great.
My build thread. As of now, 11 pages of hardly no movement and lots of research.
Jeep 4.0 in 69 Barracuda
