My Duster Adventures
FINALLY got the transmission mount “done” (need to get it sand blasted and paint it) and got it installed.
I then hung the exhaust onto the headers with one bolt, just to hold them up so I could lower the car. I then set the front end down on the ground and was blown away at how low the front end is! It’s hard to tell in this pic just how low it is, but the fender lip is at 23 3/4”!!
I’m hoping to roll the car outside tomorrow or Saturday, to clean up the garage, as well as get a good all around look of the car and take some better pics. I took a few measurements at different points of the car, here they are.
23 3/4” to fender lip
5 3/4” to torsion bar crossmember
3 7/8“ to header flange
5” to trans mount
4 1/2” to bellhousing
25 1/2” to rear quarter lip
FINALLY got the transmission mount “done” (need to get it sand blasted and paint it) and got it installed.
I then hung the exhaust onto the headers with one bolt, just to hold them up so I could lower the car. I then set the front end down on the ground and was blown away at how low the front end is! It’s hard to tell in this pic just how low it is, but the fender lip is at 23 3/4”!!
I’m hoping to roll the car outside tomorrow or Saturday, to clean up the garage, as well as get a good all around look of the car and take some better pics. I took a few measurements at different points of the car, here they are.
23 3/4” to fender lip
5 3/4” to torsion bar crossmember
3 7/8“ to header flange
5” to trans mount
4 1/2” to bellhousing
25 1/2” to rear quarter lip