More precise instructions:
- Mark the backbone wires on the burlap/frame where the listing wires will attach (this will tell you exactly where they are when looking down through the slot). Make sure these run approximately with step #3 below, the listing wire sleeve measurements.
- Insert listing wires into seat cover sleeves and measure the length of the wires (this is the length of your foam cut).
- Measure separation of listing wire sleeves at top and bottom of cover
- Transfer top and bottom separation/distance measurements to the foam (Center the separation measurements between guidelines if needed) and make dots.
- Draw a straight line between the dots and cut!
View attachment 1715716999
View attachment 1715717000
View attachment 1715717001
View attachment 1715717002
View attachment 1715717003
View attachment 1715717004