67/68/69 cuda dilemma
Spent all day with this. Making a throttle cable bracket/kick down cable bracket. Thats ok, it's one more part of the trans mockup. Needed to make sure the carb had the same idle to WOT throw, and that I was getting the kickdown cable bracket in the right spot in regards to idle spot. Using a stock Dodge Dakota kickdown cable to make replacements easy to get. I also used a ram van transmission kickdown lever, and ram van cable support on the trans end. As this raises it up about an inch above the rear fluid port.
I'd rather get this stuff done now than later. Plus I can figure the cable routing. Operates nice and smooth from idle to WOT. Kick down operates nice and smooth as well. Very happy with the results. Time to sandblast and primer the bracket. Then put it away with the carb for safekeeping.
Spent all day with this. Making a throttle cable bracket/kick down cable bracket. Thats ok, it's one more part of the trans mockup. Needed to make sure the carb had the same idle to WOT throw, and that I was getting the kickdown cable bracket in the right spot in regards to idle spot. Using a stock Dodge Dakota kickdown cable to make replacements easy to get. I also used a ram van transmission kickdown lever, and ram van cable support on the trans end. As this raises it up about an inch above the rear fluid port.
I'd rather get this stuff done now than later. Plus I can figure the cable routing. Operates nice and smooth from idle to WOT. Kick down operates nice and smooth as well. Very happy with the results. Time to sandblast and primer the bracket. Then put it away with the carb for safekeeping.