Make sure there are not any loose pieces about to come off and run that thing.Should I replace this axle because of the chip...car will only be used on street...no racing..will it destroy my internals ?
View attachment 1715730547
On the garage floor somewhere because when the axle fell over and hit an old brake drum it chipped the spline?Run it.
But where is the missing piece?
I would do this just so there are no sharp edges.I would file it smooth (jeweler's files) then sand it with some fine sand paper, make sure there are no loose pieces.....should b good to go!!!
Yes, except that the spine was hit on one side and might have deformed the adjacent side of the spline. If it is deformed it will cause interference. I would make sure that the side adjacent to the chip is not deformed, if it is it should filed flat or so that it doesn't cause a problem.I would do this just so there are no sharp edges.
Yep, dress it up. Should be good to goI would file it smooth (jeweler's files) then sand it with some fine sand paper, make sure there are no loose pieces.....should b good to go!!!