1972 Dodge Colt
Had to take a day off to celebrate my wife's birthday.
Back at it today.
Did some sheet metal work on the tunnel.
Did some countersunk rivets on the Lenco cut-out.
Also a couple of areas that had been cut and covered with loose metal.
Cut and trimmed around the shifter.
Installed the driveshaft to measure the cut.
Looks like 2.5 inches will make it work, so next week that goes to Ft Worth.
Also got 2 90 deg exhaust extensions to route the exhaust out the side.
Thanks SlantRacer, that is a good idea.
Had to take a day off to celebrate my wife's birthday.
Back at it today.
Did some sheet metal work on the tunnel.
Did some countersunk rivets on the Lenco cut-out.
Also a couple of areas that had been cut and covered with loose metal.
Cut and trimmed around the shifter.
Installed the driveshaft to measure the cut.
Looks like 2.5 inches will make it work, so next week that goes to Ft Worth.
Also got 2 90 deg exhaust extensions to route the exhaust out the side.
Thanks SlantRacer, that is a good idea.