69 Notch Barracuda - Rebirth
Intake and carb are on... mocking up and routing the fuel lines for the new (cheap) dual fuel inlet fitting. Decided to route a hard line to and up and over the distributor... then a soft line down between the heater hoses to the the pump. Seems pretty slick. Should be enough room to rotate and pull the distributor out under the hard line if needed.
I have a new throttle cable bracket on the way (mancini).
Also, the top pic shows a 1” carb spacer, but I don’t have the height needed to run it.
I did have to cut an air cleaner notch out of the rear of the inner hood scoop as well.
Intake and carb are on... mocking up and routing the fuel lines for the new (cheap) dual fuel inlet fitting. Decided to route a hard line to and up and over the distributor... then a soft line down between the heater hoses to the the pump. Seems pretty slick. Should be enough room to rotate and pull the distributor out under the hard line if needed.
I have a new throttle cable bracket on the way (mancini).
Also, the top pic shows a 1” carb spacer, but I don’t have the height needed to run it.
I did have to cut an air cleaner notch out of the rear of the inner hood scoop as well.