Best replacement pistons for stock '69 engine

Alright, got my burette in and heads (675 casting) cc'd - right at 67cc per chamber.
My block was decked slightly, but not zero-decked (or at least, I didn't ask for zero-deck). My actual deck height is therefore a bit of an unknown,
although the machine shop may be able to give me the actual number. I think I can assume a deck height between 9.59 and 9.6?

So, running the numbers for the KB167:
Cyl head volume: 67cc
Piston head volume: 5cc
gasket thickness: .043 (I think this is the regular comes-in-the-kit gasket)
gasket bore: 4.1"
Cylinder bore: 3.950" (40 over)
Stroke: 3.31"

Since deck clearance is a question, I'll run it at both extremes:
Zero deck: 9.18:1 CR
9.6" deck height: 8.94:1 CR

For the sealed power, I have to bring my deck height down to 9.55 and assume the valve reliefs take up less than 2cc before I start getting CR above 8.5. I frankly don't know how much is usually taken off with decking for a simple rebuild, but that seems like a lot. It seems would need a very thin head gasket.

So, if that checks out, it seems like the KB167 is the way to go for close to (or slightly above) stock performance.