The Dust-Turd project.
The rear trunk floor part two. Needed to make a mount for the parachute and lower the fuel cell, so we whacked the rear floor and trunk area apart again. The rear roll bar supports were just a bit off ??? and not attached properly.
Cut all that away, made some 2x2 blocks and welded them back in place and added a cross bar support.
Made an upper support and braces to mount the chute in the lower center of the rear panel.
Made some new floor panels and dropped the fuel cell 3" lower in the rear and 1" in the front.
Chute mount is removable and will pass NHRA tech now. Wheelie bars are next.
The rear trunk floor part two. Needed to make a mount for the parachute and lower the fuel cell, so we whacked the rear floor and trunk area apart again. The rear roll bar supports were just a bit off ??? and not attached properly.
Cut all that away, made some 2x2 blocks and welded them back in place and added a cross bar support.
Made an upper support and braces to mount the chute in the lower center of the rear panel.
Made some new floor panels and dropped the fuel cell 3" lower in the rear and 1" in the front.
Chute mount is removable and will pass NHRA tech now. Wheelie bars are next.