circle track cam

Have you tried a different tire? If you could get it to hook, that would be the biggest ticket, since you're obviously out powering everybody else. If you could get it to the ground, you could waste the competition. If you're dead set on a camshaft change, what I recommend is maybe calling someone at Crower. They've always been cutting edge and I believe you'll have better and a less of a "cookie cutter" approach than someone like Comp.
Spec tire rule I would guess.

I would call Mike Jones @ Jones Cams in NC. He ground my kid's MWM cam and it was dynamite (SBC). His stuff usually looks smaller on paper than the other guys cams. Sometime morons like me will disagree with his cam suggestions than realize he knows more than we do. He has a proprietory cam software and his cams use some nice, ez ramps and he uses a small 8" wheel to grind them...

He did a cam for my SLM engine (383 SBM, ported W-2's, 3.79 stroke) and I will be using that when I screw my motor together. I also have a bit hotter Howard's cam in my toolbox... hope to do an A/B comparison this winter.