I dug out the last panel needing attention, the hood. I got this hood with the car. Someone ahead of me started to chemically strip the hood and never completed the job. I eventually had the hood dipped and then I covered it with epoxy primer to protect it until I got back to it. I sanded down the surface to prep it for a new coat of epoxy and body work. Busted out the hammer and dolly to take care of some boo boos that I could reach from the back side. I have recoated it with a fresh new coat of epoxy and applied some filler to the areas where there are some low spots. With luck, I will be able to block these areas and get a final coat over the body work before the weather here turns to crap!
Question for you guys . . .
The deck lid is not original to the car. I just noticed in the past few days that the lid has no holes punched in it for the Dodge or Swinger badging. The access holes are present in the inner frame and it clear that there were never any holes for these emblems. Is anyone aware of a source for the measurements needed to drill the needed holes in the lid? Thanks for your help in advance! L8r
Jim