Gerahead's 71 Dart

Geez, it has been longer than I thought since I did an update! Got wrapped up in a home remodeling project that took me longer to finish than it should have.
When I stopped work on the project last Fall, I had applied a couple of good coats of high build primer thinking I was pretty much done with the body work. I had done the body work to that point with a sanding block that was about 22" long. When I was getting ready to block out the high-build, it looked like the body accent lines still weren't where I wanted them. I bit the bullet and got a sanding block about 32" long for this work. Applied some guide coat and went to work with my new acquisition. For the most part, the doors and quarters turned out pretty well. There were still some low spots in the stampings, but all in all, pretty decent. Over the last few days I have added some filler to the low spots, roughed it back in and squirted a couple new coats on the panels needing attention. Today I will get back at it with the sanding block and see where I'm at. I'm hoping that my work with filler is done! Fingers crossed! L8r

Jim