Fan relay and sniper install

Copy that. @67Dart273. I am going to swap out the hi pressure switch with a trinary unit and run from there to 86. Ill run 85 to EFI. Ill run 30 amp fused from dash to 30 and 87 to fan unit. I will research if I should utilize the diode wire or the non diode wire to the EFI out of 85. By running the trinary switch I will not be splicing and dicing my signal from the pressure switch (switched 12 v) Ultimately as to not fry EFI I will not make that connection until I have system powered up to verify it IS NOT getting more than it needs...I think it can only handle 2 amps...not sure what that is in voltage yet....baby steps here now.

Thank you fellas.....we gettin there, just aint there yet-Rat Rod Bob