Small block TrickFlow heads part 1
Ok finally got this flowsoft program up and running. Windows 10 sure did make things harder on an old program like this. Ok I checked calibration with a 300cfm plate and as always it checked in at 299-301. My bore adapter measures 4.015 and TrickFlow says they use a 4.000 bore so that’s close. Real close. My numbers are on the left and TrickFlows advertised numbers are on the right. I expected close numbers and as you can see they came in close. These heads should make power BUT I’m going to show what I think is holding them back some. Hopefully it can be addressed.
Ok finally got this flowsoft program up and running. Windows 10 sure did make things harder on an old program like this. Ok I checked calibration with a 300cfm plate and as always it checked in at 299-301. My bore adapter measures 4.015 and TrickFlow says they use a 4.000 bore so that’s close. Real close. My numbers are on the left and TrickFlows advertised numbers are on the right. I expected close numbers and as you can see they came in close. These heads should make power BUT I’m going to show what I think is holding them back some. Hopefully it can be addressed.