67/68/69 cuda dilemma
A bit more on the left side. I think I am done for the weekend. Was also screwing around with my panel flanger. This thing will do nice radiuses. The flanger will flange 1" down from the quarter panel top crease and not warp the panel. Practiced on the one I cut off. I do believe these goodmark half skins are gonna go on decent and fit just fine. So much more to do up in there before I can even think about putting them on though. Now the project is gonna slow down as I repair the rusted areas, and repair the roof supports that were cut out. Plus I go to an 8 day on, 6 day off schedule at work, heading into my 8 days on shift next week. I am not going to be fooling with it much during that time.
A bit more on the left side. I think I am done for the weekend. Was also screwing around with my panel flanger. This thing will do nice radiuses. The flanger will flange 1" down from the quarter panel top crease and not warp the panel. Practiced on the one I cut off. I do believe these goodmark half skins are gonna go on decent and fit just fine. So much more to do up in there before I can even think about putting them on though. Now the project is gonna slow down as I repair the rusted areas, and repair the roof supports that were cut out. Plus I go to an 8 day on, 6 day off schedule at work, heading into my 8 days on shift next week. I am not going to be fooling with it much during that time.