Dad’s 1969 Dodge Dart Swinger 340
Headliner time. First was the insulation. I used some left over Dynaliner. Nothing exciting there. Sail boards went up next. I drilled the nail hole out to 5/32 and used some small panel push pins to hold it in place. I actually drilled a 2nd hole towards the back near the rear window for a 2nd pin. Installed the bows, trimmed the listing channel, and hung them. We used binder clips and started clipping the front and rear. We had to cut a lot of material out of the rear because the headliner I got didn’t have the back window portion cut out. Today I think we will trim some more out so we can start pulling the material.
Headliner time. First was the insulation. I used some left over Dynaliner. Nothing exciting there. Sail boards went up next. I drilled the nail hole out to 5/32 and used some small panel push pins to hold it in place. I actually drilled a 2nd hole towards the back near the rear window for a 2nd pin. Installed the bows, trimmed the listing channel, and hung them. We used binder clips and started clipping the front and rear. We had to cut a lot of material out of the rear because the headliner I got didn’t have the back window portion cut out. Today I think we will trim some more out so we can start pulling the material.