Steering column rebuild 67 barracuda
Ok. so after a couple more attempts to make the stock bolts that hold the upper column 'bell' together, I made some that seem to work!
Original on the left this pic
Original on right on this pic.
Square headed 1/4" x 20 or 24 offset.....done!
they seemed to give me less headache and grabbed the square holes they seemed to line up with in the lower piece so....
There it is!!
Next need to find the plastic spacers that hold the mid shaft tube in place. They go in the "netted" looking area of the outside tube. All sources to be revealed by the all knowing FABO.....Ya?
Ok. so after a couple more attempts to make the stock bolts that hold the upper column 'bell' together, I made some that seem to work!
Original on the left this pic
Original on right on this pic.
Square headed 1/4" x 20 or 24 offset.....done!
they seemed to give me less headache and grabbed the square holes they seemed to line up with in the lower piece so....
There it is!!
Next need to find the plastic spacers that hold the mid shaft tube in place. They go in the "netted" looking area of the outside tube. All sources to be revealed by the all knowing FABO.....Ya?