6.1 Hemi 69 Barracuda Fastback Father Son Project

Joe Mc said
Thanks for all info and pictures.
Questions:
1-The socket on shock end threads off? Not sure how/where you used the 1" threaded extension? On picture it looks to be on the top/hood end of shock.
Maybe just me not quite sure of that particular detail?
2-If ever the shocks need to be replaced how difficult would that be?
I have a hard tonneau on my truck and over the 21 years I've owned it I've replaced the shocks 3 times and recently one just failed so...
BTW when I bought 1st replacement set guy at the truck center told me to make sure the extending shaft faces up otherwise the oil would prematurely leak.
Very nice execution :thumbsup:

I only extended the length because I went from 15" to 14" to get the 220 lb. struts. Yes, the ball socket unscrews. That is how I made my 14" into 15".
If you start with 14", you won't need to extend them... Just place the bottom Ball stud up an inch higher.
Manufacturer recommends shaft down to keep the seal oiled and prevent the seal drying out.
If I ever have to replace, I will only have to remove the splash shield.
Been in there a few times with the fender on. Had the hinges on and off with the fenders on. That's not fun but it is doable. Will be easier to do with the struts.