Turn signals not working, blowing fuse
Regretfully I am back to square one. Blowing fuses. Worked for a few minutes, now it’s the same issue.
this is really discouraging. Am I going to have to take my dash apart.
this is really bumming me out.
Maybe some wires moved around with the flasher out.
I think you can narrow where to look.
Use the ohmmeter or continutiy check on the flasher unit that was removed.
The two terminals should have continuity. The feed terminal should not have continuity to the shell. If it does, then that was a problem.
Next, remove the fuse and see if there is continuity between the fuse terminal and ground. If so, then at least you know for sure its a short to ground your hunting.
So knowing that, now go ahead and disturb the flasher wires. Remove the new flasher unit and take a probe to the flasher connector feed terminal. Take the other probe to ground. If there's continuity, then that wire is grounding.
If not, then check th eother side of the connector. That side is going to the turn switch and we know column connectors and wires can get damaged.