I put it into gear and it dies.
So I have some news. I am cleaning out all the connectors under the hood and it has been going smoothly, every single connection so far I have touched (that I did not put new ends on) have been white with corrosion. So I got to the first bulkhead connector and it was filled with dirt, corrosion, etc, and I was able to make all the connections in there shiny and new almost. good.
Now I pulled off the center connector and something is a little bit fucky;
As you can see, the clips are broken off and the bottom fusible link terminal is twisted sideways and some of the plastic has been broken off. (someone has been in here before.) But my biggest issue is on the top right. That fusible link connector on the bulkhead is not even there and there is no wire on the other side.
Is that normal?
because if not, that is my whole issue.
So I have some news. I am cleaning out all the connectors under the hood and it has been going smoothly, every single connection so far I have touched (that I did not put new ends on) have been white with corrosion. So I got to the first bulkhead connector and it was filled with dirt, corrosion, etc, and I was able to make all the connections in there shiny and new almost. good.
Now I pulled off the center connector and something is a little bit fucky;
As you can see, the clips are broken off and the bottom fusible link terminal is twisted sideways and some of the plastic has been broken off. (someone has been in here before.) But my biggest issue is on the top right. That fusible link connector on the bulkhead is not even there and there is no wire on the other side.
Is that normal?
because if not, that is my whole issue.