289 vs 318 ..... Ford vs Mopar

I have thrown some parts out of both Chevy and Ford motors. I have never (probably shouldn't say this) thrown any parts out of the bottom of a Mopar engine. Yes, I know it can be done but, I feel it's much harder to do in a Mopar engine and, here is why....Rod angle, look at how much wider Mopar engines (big block and small blocks) are than the competition. The width of the engines make it much easier on the rods under load and rpm to push the piston back up the cylinder. The Ford small blocks are almost unnatural on how up and down the cylinders are and, makes more likely to put some parts on the outside of the engine...lol Rod angle, in my eyes the same reason the slant six is...well...slanted.