I wonder if a guy could hack up a truck manifold for the long outlet and mill both the manifold and outlet to make the correct exit angle? I have been keen on experimenting with iron MIG wire for some time now.
My biggest fear is having to modfy the geometry of the z-bar. I dont like changong the geometry of that system because it causes various problems, especially power shifting it. A crooked z bar is not an acceptable solution to me. If the z bar is crooked it will bind up the linkage under the dash and things start wearing and fail. They bb a body only 7/16" clutch p/rod is getting hard to find. If this project continues to spiral out of control I might use a spare pedal assy and hiem joint the clutch linkage to take out the factory engineered slop. Both of my Chargers are done that way if it makes a world of difference IMO.
How about a few pictures for inspirational purposes
View attachment 1715860872
View attachment 1715860873
View attachment 1715860874
View attachment 1715860875
View attachment 1715860876
View attachment 1715860877
View attachment 1715860878
View attachment 1715860879
View attachment 1715860880
View attachment 1715860881
View attachment 1715860882