64 Dart
Got the engine in today, what a ***** are the motor mounts! I didn’t have proper ones, i tried to modify all sets that i had, non of them were right, every time when i would get close oil pan will be resting on the k member, had to use thick biscuits on both sides.
Eventually i used the 67-72 i think mounts with a thick biscuits. It look all right, what do you guys think? Also before i bolted down the driver side biscuit it won’t sit flush! What made me everything questionable! Any advice on that?
I want to do engine plate next, so want to make sure engine is sitting right!
Also flex plate shield and transmission scattered shield totally were not fitting, had to modify fire wall and floor, and now I don’t have room for gas pedal, so i had to move brake pedal and modify gas pedal too, will finish it tomorrow!
welded in a lip for rear firewall
And worked a little on the relay panel and wiring
and the motor is in!
Got the engine in today, what a ***** are the motor mounts! I didn’t have proper ones, i tried to modify all sets that i had, non of them were right, every time when i would get close oil pan will be resting on the k member, had to use thick biscuits on both sides.
Eventually i used the 67-72 i think mounts with a thick biscuits. It look all right, what do you guys think? Also before i bolted down the driver side biscuit it won’t sit flush! What made me everything questionable! Any advice on that?
I want to do engine plate next, so want to make sure engine is sitting right!
Also flex plate shield and transmission scattered shield totally were not fitting, had to modify fire wall and floor, and now I don’t have room for gas pedal, so i had to move brake pedal and modify gas pedal too, will finish it tomorrow!
welded in a lip for rear firewall
And worked a little on the relay panel and wiring
and the motor is in!