New hammer what will it run?

What will the trickflows flow?

My 408 ran a 260/264 @ .050", .628/.633 flat solid with ported Edelbrocks that flowed 293 @ .650", deep port matched Victor with a Biggs 950. It ran fastest shifting at 64-6600, anything more or less and it slowed down.

My 434 has a solid roller, 263/271 @ .050", .711/.719" measured at the retainers with Indy heads and intake. On the dyno it made peak power at 6700 and I normally shift it at 7-7200. It has ran 6.25 in the 1/8, on that pass the 1-2 shift was at 7800, for whatever reason I was bad late :realcrazy:.

I'm thinking you have the cam to pull to 7k but not sure the heads will support it. If it pulls clean I'm guessing 10.20's, if not 10.40.

my buddy with the trickflows on his stroker has that nice 264-268 Hughes solid. 620 ish lift with his 1.6’s.
Its done at 6500-6600 running 1/4 mile. Good gear for the combo i think
So i think you are correct.
OP i think has a 28 tire and 4.10 gear, shouldn't get past 6600-6700 i wouldn't think.
Be curious to see how his convertor works. 5600( if that is where it indeed ends up) seems a bit much to me, but i could be wrong..it for sure wont be WAY off.