Rocker Arm help

Rat Bastid,
Tell us about your vast rocker geometry experience that you claim is better than mine. I started in 1969 with a 1380cc Vee twin engine I designed. When did you start?
You are going to block me? Great, can you make that a promise!!
With all of your low rent criticism of me & where I live, it still doesn't change this fact: you are still wrong if you think the rocker in post #1 needs to be raised.
This is YOUR quote from post #41: "The shaft has to go UP & AWAY from the valve for it to be correct."
That would move the roller tip even closer to the valve tip edge on the exh side, when it needs to go in the other direction. 10000000000% wrong.
Notice nobody else has suggested raising the shaft? Hmm. It certainly wouldn't be because you are the sharpest knife in the drawer & got it right...