WRIST PIN FIT?

PRH said
Without a proper fixture for pressing out piston pins, what usually happens during that process is the piston gets distorted, and is then basically junk.

Also, with the galling shown in the one pic, it was likely tight enough so that the piston skirt is slightly collapsed now.
Easy enough to tell with a mic.

Thanks for your input. Rods and pistons going in the pile to build another Hyundai.:( So much for my low budget build.

Just trying to get the car on the road and trying to minimize machine shop time. Would these Speed Pro pistons (L2613F)and a set of reconditioned floating pin 340 rods require balancing? Hoping to put it together myself.

Thanks