WRIST PIN FIT?

pishta said
Id ship you a set of pulled 340 floater rods but your in Canada. I always try to use floaters as it does not require a rod deforming press for any work but the MP cast magnum stroker pistons are press fit so I'm in the same boat. I got them on LA rods, all on but 2 are a little firm. 6 I can rattle back and forth just wagging the rod, but the last 2 require me to physically move them. I hope they wear themselves in. These pistons are no longer available to buy 2 new ones.
Click to expand...
After going through what I went through, I wouldn't trust those tight ones to "wear in". They would be off to a machine shop to have the holes reamed, or whatever they do to make them slick. I found evidence of scuffing because the rods and pistons were not articulating properly. One man's opinion.....