Best cocktail

Yea, the cam turned out to not be as stubborn as I thought and pushed out with a bit of motivation (hammer and I heated it up a bit since I have the torch out still) only the rear most cam bearing was rusted. Now to remove the cam bearings (i have the tool)

Just got done with power washer round one and got it cleaned up a lot.

The cylinders that were stuck don't look so bad now but this just shows how little it takes to prevent the piston from moving.

20220316_170739.jpg

20220316_170753.jpg

20220316_170815.jpg

20220316_170819.jpg