1964 Dart Grüne Hölle Road Course/Track Day/AutoX Project

2/14/22:

I was able to get some more work done on the car over the weekend.

I Ordered some Sparco R100 Street Seats - They are affordable and have Provisions for Head and Helmet support, Belt Holes as well as side bolsters to support you in the corners a bit. I am sure they are not the best seat but they are good upgrade from the stock seats at this point, which were heavy, high and dropping webbing and foam all of the time.

There are not any ready Made Bolt in Siding Seat Brackets that I could find for the '63-'66 A Body MoPars.. so I bought a Corbeau Seat Bracket/ Slider for the '67-'76 A Body. It of course did not fit but with a bit of Tab relocating / Welding and other typical hotroddery I was able to Fit the Sparco Seat to the Corbaeu Sliders and Fit the Sider / Bracket to the Floor of the car.

Welding and fitting to make the bracket fit this car:
51881448683_59f1260caa_c.jpg
51881689309_d156fe101d_c.jpg

Sparco's have a wider track for the sliders than the Corbeau's so I added some Oversized tube and sleeved / welded the seat adjuster handle.
51880403522_463e66eec1_c.jpg
51880403507_5268b15456_c.jpg
51880403477_aebb47edc1_c.jpg

Lots of test fitting to fit a floorboard with goofy stock mounting points and reinforcement plates not underneath the bracket I was adding.
51881369216_d82c88c541_c.jpg
51880403422_b4c4588f17_c.jpg

All Painted up..
51881369191_bd26391698_c.jpg

Started Working on the Harness Bar for the Shoulder Belts.
The Piece Below the quarter window on the '64 Dart is metal, not trim, not removable.. It;s Part of the unibody Structure, so Harness bar will get welded to it.
51881689159_1075539e71_c.jpg
51881369126_68793fa09c_c.jpg

'Till next time,
Greg