68 Barracuda front to rear brake line route

CRUZE 418 said
My '69 Dart and '72 Dart start out at the distribution block, if you are original, you may have a second distribution block about 12" down stream of the main distribution block. The line then goes through the cross member (trans) then hugs the inside of the rocker panel back to the front of the leaf springs then there is a joggle to the frame rail up and back then makes a 90° turn to its holder where a flex line then goes to the axle housing.
Are you trying to make this or do you have the whole line from inline tube or some other source?
Here's a picture of the old line from my '72.
If you used usct frame connectors, you will have a problem with the crossover after it goes through the trans crossmember. Same issue on the other side of the car with the fuel line.

View attachment 1715895106
Click to expand...
CRUZE 418 said
My '69 Dart and '72 Dart start out at the distribution block, if you are original, you may have a second distribution block about 12" down stream of the main distribution block. The line then goes through the cross member (trans) then hugs the inside of the rocker panel back to the front of the leaf springs then there is a joggle to the frame rail up and back then makes a 90° turn to its holder where a flex line then goes to the axle housing.
Are you trying to make this or do you have the whole line from inline tube or some other source?
Here's a picture of the old line from my '72.
If you used usct frame connectors, you will have a problem with the crossover after it goes through the trans crossmember. Same issue on the other side of the car with the fuel line.

View attachment 1715895106
Click to expand...
Thanks for taking the time Cruz, that helps a bunch now at least I know where to unbend this thing and yes I used usct connectors. I haven't been under the car with this info yet, wondering if a new hole through the connector is a possible option. I have a new ss line from, hell I can't remember now which vendor.
CRUZE 418 said
My '69 Dart and '72 Dart start out at the distribution block, if you are original, you may have a second distribution block about 12" down stream of the main distribution block. The line then goes through the cross member (trans) then hugs the inside of the rocker panel back to the front of the leaf springs then there is a joggle to the frame rail up and back then makes a 90° turn to its holder where a flex line then goes to the axle housing.
Are you trying to make this or do you have the whole line from inline tube or some other source?
Here's a picture of the old line from my '72.
If you used usct frame connectors, you will have a problem with the crossover after it goes through the trans crossmember. Same issue on the other side of the car with the fuel line.

View attachment 1715895106
Click to expand...
CRUZE 418 said
My '69 Dart and '72 Dart start out at the distribution block, if you are original, you may have a second distribution block about 12" down stream of the main distribution block. The line then goes through the cross member (trans) then hugs the inside of the rocker panel back to the front of the leaf springs then there is a joggle to the frame rail up and back then makes a 90° turn to its holder where a flex line then goes to the axle housing.
Are you trying to make this or do you have the whole line from inline tube or some other source?
Here's a picture of the old line from my '72.
If you used usct frame connectors, you will have a problem with the crossover after it goes through the trans crossmember. Same issue on the other side of the car with the fuel line.

View attachment 1715895106
Click to expand...