67/68/69 cuda dilemma
Gonna do this in picture installments. Theres quite a bit to this. Ok, so heres the issue. With the skin held on with cleco pins, the wheel opening clamped to the front edge of the trunk drop, and at the front side of the wheel house where it actually fits in both spots, I stacked up tongue depressors in the gaps at the top and at the back until they fit snug. Then i removed them, taped em together, measured the thickness and marked them. And marked the quarter skin, and wheel arch where each stack of tongue depressors went and the thickness of the gap. Then I cut the lip off.
Note: the green line (witness mark) at the back edge marked 3/8". When the lip was cut and adjusted, you can see it now doesnt line up. Later on you will see that its lined back up after I cut the lip above it to move it back in position to where it needs to be.
Gonna do this in picture installments. Theres quite a bit to this. Ok, so heres the issue. With the skin held on with cleco pins, the wheel opening clamped to the front edge of the trunk drop, and at the front side of the wheel house where it actually fits in both spots, I stacked up tongue depressors in the gaps at the top and at the back until they fit snug. Then i removed them, taped em together, measured the thickness and marked them. And marked the quarter skin, and wheel arch where each stack of tongue depressors went and the thickness of the gap. Then I cut the lip off.
Note: the green line (witness mark) at the back edge marked 3/8". When the lip was cut and adjusted, you can see it now doesnt line up. Later on you will see that its lined back up after I cut the lip above it to move it back in position to where it needs to be.