A833 no shift
I had basically the same problem, but my clutch wouldn't disengage after everything warmed up.
* The rod between the clutch pedal and Z bar was installed backwards. The bends in the bar were facing the wrong side so the bar was not centered in the firewall opening.
* The Z bar ball that attaches to the bell housing was loose where the stud attached to the mounting plate and wobbled under pressure.
* The Z bar arm to the rod that went to the clutch fork was bent. (pic)
* The input shaft was binding on the pilot bushing to the point that the end of the input shaft became discolored. (pic)
Good luck!!
I had basically the same problem, but my clutch wouldn't disengage after everything warmed up.
* The rod between the clutch pedal and Z bar was installed backwards. The bends in the bar were facing the wrong side so the bar was not centered in the firewall opening.
* The Z bar ball that attaches to the bell housing was loose where the stud attached to the mounting plate and wobbled under pressure.
* The Z bar arm to the rod that went to the clutch fork was bent. (pic)
* The input shaft was binding on the pilot bushing to the point that the end of the input shaft became discolored. (pic)
Good luck!!