360 Magnum building on an existing bottom end
Not a Guru. I just did a similar 5.9 magnum build. Looking at your mill I would check rod and crank bearings (mine were good) send the cam to Oregon cam grinders for regrind (I used the cam listed below .528/.536) and Hughes 1110 spring set and cam eccentric assuming mechanical fuel pump. Clean and reuse your lifters. Measure for pushrod length. My stock pushrods were perfect with my cam. Carefully go over your heads. I used Aussie EQ's which are no longer available. Runs great.
Not a Guru. I just did a similar 5.9 magnum build. Looking at your mill I would check rod and crank bearings (mine were good) send the cam to Oregon cam grinders for regrind (I used the cam listed below .528/.536) and Hughes 1110 spring set and cam eccentric assuming mechanical fuel pump. Clean and reuse your lifters. Measure for pushrod length. My stock pushrods were perfect with my cam. Carefully go over your heads. I used Aussie EQ's which are no longer available. Runs great.