Aussie VC 67 Dodge ute
With fitting Vintage Air gen2 it has to be mounted to the left of centre because of the steering column and the internal wiper mechanism. This means both foot well vents are on the passengers side, so I made a fibreglass duct to retain a drivers vent. I was going to make a duct to take the cold air and run through the drinks holder. But I’m currently looking at using Peltier units (an electronic unit that once voltage is applied, one side gets hot & the other cold) I’ll update that later!
With fitting Vintage Air gen2 it has to be mounted to the left of centre because of the steering column and the internal wiper mechanism. This means both foot well vents are on the passengers side, so I made a fibreglass duct to retain a drivers vent. I was going to make a duct to take the cold air and run through the drinks holder. But I’m currently looking at using Peltier units (an electronic unit that once voltage is applied, one side gets hot & the other cold) I’ll update that later!