Stop in for a cup of coffee
Got the back wall pieced in and put some mud at lower where it can be seen if you look under the vanity. Nothing fancy there, Molding will cover half of it, but didn't want to see the edges of the patch panel. Also ran another coat on the side wall that I could still see a dip at the patch. Then on to the car... While at Carlisle I was getting stuff out and splashed Powerade on the seats and console. Didn't think much of it at the time. Most of my buttons were sticking and I could see little spots of sugary goo along the edges. Was able to use the back edge of the knife to clean out and all are working. Otherwise, did find how to take all apart and clean them. I figure that will happen eventually, but all good for now.
Got the back wall pieced in and put some mud at lower where it can be seen if you look under the vanity. Nothing fancy there, Molding will cover half of it, but didn't want to see the edges of the patch panel. Also ran another coat on the side wall that I could still see a dip at the patch. Then on to the car... While at Carlisle I was getting stuff out and splashed Powerade on the seats and console. Didn't think much of it at the time. Most of my buttons were sticking and I could see little spots of sugary goo along the edges. Was able to use the back edge of the knife to clean out and all are working. Otherwise, did find how to take all apart and clean them. I figure that will happen eventually, but all good for now.