Need help on correct linkage.. who makes it
Get all that cobble crap off of the linkage. Get the adapter and mopar throttle stud like TMM said.
Like this (pic stolen from krazykuda):
I don't recognize what you've got for a cable bracket, but that needs to go, too.
This shows the travel of the carb linkage:
To achieve full throttle, the stud needs to rotate below horizontal, so the throttle cable bracket needs to be a bit LOWER than the throttle shaft in order to pull the linkage fully open. A bracket mounted as high as yours appears to be will never be able to pull the linkage "down" to get the last few degrees of throttle opening.
I see you're running an SP2P manifold, so I'm not sure the bracket TMM showed will fit, but it very well may. Otherwise, either mod a factory 2 bbl. bracket or get a 4 bbl. bracket.
Mancini Racing - Throttle Cable Bracket
Then you'll be golden!
Get all that cobble crap off of the linkage. Get the adapter and mopar throttle stud like TMM said.
Like this (pic stolen from krazykuda):
I don't recognize what you've got for a cable bracket, but that needs to go, too.
This shows the travel of the carb linkage:
To achieve full throttle, the stud needs to rotate below horizontal, so the throttle cable bracket needs to be a bit LOWER than the throttle shaft in order to pull the linkage fully open. A bracket mounted as high as yours appears to be will never be able to pull the linkage "down" to get the last few degrees of throttle opening.
I see you're running an SP2P manifold, so I'm not sure the bracket TMM showed will fit, but it very well may. Otherwise, either mod a factory 2 bbl. bracket or get a 4 bbl. bracket.
Mancini Racing - Throttle Cable Bracket
Then you'll be golden!