A body lower control arm shaft kit.

72bluNblu said

Yes, that’s a problem. The shoulder of that bushing needs to sit flush against the shoulder on the LCA. When installed the bushing should be up against the shoulder of the LCA pivot pin on one side and against the LCA on the other.

View attachment 1715974559

View attachment 1715974560

Click to expand...

Would it be best to remove shaft and continue pressing poly bushing until seated and then reinstall shaft?

Will the excess poly that is pushed past bottom seating area interfere with torsion bar installation?

I stopped pin installation when pin collar was firmly seated on poly collar. Rather than removing pin, would continued press on pin installed in poly bushing work or would the collar of pin start to go into poly bushing.

It would be nice if poly bushing was trimmed to correct length.

I’m new at this and don’t want to destroy this kit trying to install it.

Many thanks!