AlV 69 Dodge GTS project
Long time no post but I finally got caught up. I bought a set of Comp 1622-16 ultra pro magnums and longer pushrods to go with them. The stocks pushrods were too short. While I was in there I swapped the eddie performer with the performer RPM. and bought a thermostat housing riser to accommodate the additional ports I needed for the Fitech system. the valves seemed to be okay if a covered in a bit of carbon so I cleaned them and rolled with it. the cam seemed okay so I rolled with that too.
Valves
Eddie
Comp Rockers and rods, you can also see the thermostat riser. one thing that happened was that the Mopar performance cast valve covers hit the intake and would not seal properly so rather than grinding I doublestaked the gaskets which seems to be working great.
Keep it rolling! :)
Long time no post but I finally got caught up. I bought a set of Comp 1622-16 ultra pro magnums and longer pushrods to go with them. The stocks pushrods were too short. While I was in there I swapped the eddie performer with the performer RPM. and bought a thermostat housing riser to accommodate the additional ports I needed for the Fitech system. the valves seemed to be okay if a covered in a bit of carbon so I cleaned them and rolled with it. the cam seemed okay so I rolled with that too.
Valves
Eddie
Comp Rockers and rods, you can also see the thermostat riser. one thing that happened was that the Mopar performance cast valve covers hit the intake and would not seal properly so rather than grinding I doublestaked the gaskets which seems to be working great.
Keep it rolling! :)