Low buck 360 build
Playing around with the intake this morning. Goal was to block off the exhaust crossover on the smog era manifold. Whipped up some Marine Tex gray epoxy (which is super badass stuff BTW) and trimmed out the gasket openings from some thin sheet metal. I used thin metal to make sure it doesn't interfere with gasket sealing on the intake manifold.
I also went ahead and did the same thing to the cover plate. I ground off the vacuum control gizmo and sealed it up. I don't think the pieces on the intake will leak but I figured it doesn't hurt to have this anyway.
A bit of aluminum HVAC tape to hold the pieces in place while the epoxy dries.
Playing around with the intake this morning. Goal was to block off the exhaust crossover on the smog era manifold. Whipped up some Marine Tex gray epoxy (which is super badass stuff BTW) and trimmed out the gasket openings from some thin sheet metal. I used thin metal to make sure it doesn't interfere with gasket sealing on the intake manifold.
I also went ahead and did the same thing to the cover plate. I ground off the vacuum control gizmo and sealed it up. I don't think the pieces on the intake will leak but I figured it doesn't hurt to have this anyway.
A bit of aluminum HVAC tape to hold the pieces in place while the epoxy dries.