My Duster didn't originally have a console so I just made my own. It's not quite in the factory location, it's located to put the T56 shifter in the middle of the top plate so it's a little bit further back than the factory console location. Probably only a few inches though really. The front mount is just a piece of flat stock I bent up, the rear mounts are a section of rectangular tubing leftover from making a set of frame connectors. I just cut a slice of the end that was about 1.5" wide so I had an open rectangle and then cut it so it was the right height to meet up with the console. Wasn't going to pay $90+ for the AMD reproduction brackets, especially since they still might have needed modification for the T56 tunnel anyway