1965 Barracuda 273 rebuild...intake code?

Good combo to run

920s for the heads. You can run a 1.88 valve cut down to 1.84. With the 1.84 intake you won’t have any shrouding. You didn’t say if you have to go overbore on the cylinders. If you have to bore the block have fun finding pistons. Just went through that exercise. EGGE and Canter are a source however when I talked with EGGE they we’re out of stock of the flattop pistons. Kanter had the 10 to 1 pistons however they only had standard and .010 over pop ups. No flat tops.

E4 grind Isky cam. Oregon Cam can make up a camp for you. They can get you a a hydraulic cam close to the E4 specs. Take your old lifters and send them to Oregon Cam to have the refurbished. Most if not all lifters today are made offshore. Lots of wiped out camshafts and unhappy owners.

Edelbrock LD4B. If you run the 920s you won’t have to elongate the bolt holes.

Carter 9636 or 9635. Carb was discontinued years ago however plenty of them on the net


Oh, I see you finished the motor. Good luck with your car.