Would you run these axles?
Take a look at the pictures. I filled in the sbp holes because the bbp holes were drilled too close, there was only 1/16” of flange material between the holes. Now I need to open the existing holes to accept a 1/2” stud. They are currently drilled for OEM 7/16” studs. Original stud and new stud included in pictures. Is the axle still viable? Would you run it on a street driven weekend cruiser? Here is a picture of the other axle before welding the holes. The two sets of holes are not as close together as this axle. But I think I'll still weld them up.
Take a look at the pictures. I filled in the sbp holes because the bbp holes were drilled too close, there was only 1/16” of flange material between the holes. Now I need to open the existing holes to accept a 1/2” stud. They are currently drilled for OEM 7/16” studs. Original stud and new stud included in pictures. Is the axle still viable? Would you run it on a street driven weekend cruiser? Here is a picture of the other axle before welding the holes. The two sets of holes are not as close together as this axle. But I think I'll still weld them up.
