360 Magnum Build SFS (S-crounging F-or S-craps)
Took a little time today to baseline the Chinesium. I had low expectations and they undershot those. :(
So quickly revised the VJ, removed some material around the valve, and blended the ridge where their machining left off at the valve job. Results are in the photo. I'm only targeting 265-270 cfm as I only intend on 450-500 hp and plan on keeping the port "high and tight". J.Rob
Took a little time today to baseline the Chinesium. I had low expectations and they undershot those. :(
So quickly revised the VJ, removed some material around the valve, and blended the ridge where their machining left off at the valve job. Results are in the photo. I'm only targeting 265-270 cfm as I only intend on 450-500 hp and plan on keeping the port "high and tight". J.Rob