Open chamber Edelbrock head this time
Waiting on payment and all I have to do to a finished set of Speedmaster heads is set up the springs, leave the inners out, and ship them out. So I stripped down one head so I could get it in my tank. I’m not a big fan of porting stuff that was already worked on but these have minimal work done. Someone was of all things brave enough to work over the short turn lightly then they lightly buffed the bottom of the intake runner and half the bowl. They got more aggressive on the gasket match. This is we’re I tell you guys if you are going to do it go further into the port. Here’s a few quick shots. The valve job may or may not of been touched but it looks stockish. These will get ported and upgraded to a 2.055 Ferrea valve. Exhaust port looks stock. I will update with flow numbers as delivered later this week.
Waiting on payment and all I have to do to a finished set of Speedmaster heads is set up the springs, leave the inners out, and ship them out. So I stripped down one head so I could get it in my tank. I’m not a big fan of porting stuff that was already worked on but these have minimal work done. Someone was of all things brave enough to work over the short turn lightly then they lightly buffed the bottom of the intake runner and half the bowl. They got more aggressive on the gasket match. This is we’re I tell you guys if you are going to do it go further into the port. Here’s a few quick shots. The valve job may or may not of been touched but it looks stockish. These will get ported and upgraded to a 2.055 Ferrea valve. Exhaust port looks stock. I will update with flow numbers as delivered later this week.