Restart the rebuild
Well, got some shop time in sporadically. Took a couple times to get JP Performance TC set (thanks @Max1196) installed as close as possible dot to dot.
I went to a website that allowed you punch in cam card specs and would lay them out on the degree wheel. Then print it off. I taped it to a crude 8" wheel I made from masonite. I kept finding it would compress and throw off measurements. Reinstalled a Mr Gasket one and used the printed one as cheat sheet.
Took a couple times, have to fine tune my measuring "skills" lol.
My max lobe lift was .329", that was at 107* ATDC. 0.050" on either side of that gave me 153* ATDC and 64* ATDC. So adding the 153+64=217รท2=108
5. 2nd time around gave me 109* ICL.
This is installed straight up.
Cam card states 106* ICL.
Opinions? Dial indicator and degree wheel still hooked up.
Thanks all!
Well, got some shop time in sporadically. Took a couple times to get JP Performance TC set (thanks @Max1196) installed as close as possible dot to dot.
I went to a website that allowed you punch in cam card specs and would lay them out on the degree wheel. Then print it off. I taped it to a crude 8" wheel I made from masonite. I kept finding it would compress and throw off measurements. Reinstalled a Mr Gasket one and used the printed one as cheat sheet.
Took a couple times, have to fine tune my measuring "skills" lol.
My max lobe lift was .329", that was at 107* ATDC. 0.050" on either side of that gave me 153* ATDC and 64* ATDC. So adding the 153+64=217รท2=108
5. 2nd time around gave me 109* ICL.
This is installed straight up.
Cam card states 106* ICL.
Opinions? Dial indicator and degree wheel still hooked up.
Thanks all!